legs- Spade leg- Most common-
over 6 feet long- 22-1/4 inches high by 18 inch top piece
$ 158.00 each
Grands under 6 feet long-
21-3/8 inches high by 16 inch top piece
SH842 $ 125.00
legs- Straight tapered-
inches high by 16 inch top piece- Ferrule suggested
$ 121.00 each
$ 258.00 each
Traditional "Period" literal
lyre shape- call for availability
not available at this time
Read our instruction on repairing your grand lyre.
Grand Piano round mounting plates here
Square Grand Legs and Desks available below
We hear over and over of movers losing the whole lyre assembly
mounting brass hardware. The lyres and kit below are matched and
You may have to do some fitting tricks to make the lyre work. But,
the only complete outfit we can find anywhere.
are seen up this page.
Straight line Spade Foot Style Lyre
Hard maple or birch-- 23 inches
high, top bar is 12 inches by 2-3/8 inches
A cabinet maker may be able to remove the top bar and shorten the
height of the lyre
if a shorter lyre is needed.
Bottom box is 8-1/2 inches wide-- 3-1/8 inches deep.
No metal parts included
Louis XV Style Lyre- For French Provincial also and Square Grands
Lyre can be disassembled
by removing lag bolts
that overall height can be altered.
Hard maple or birch-- 23 inches high, top bar is 12 inches by 4-7/8
Bottom box is 10 inches
wide-- 4 inches deep.
metal parts included call for availability
Not available at this time
Solid Brass Lyre Hardware Kit for a used or new lyre
This is needed especially
where movers lost the whole lyre.
This kit is designed to go with SH845 and SH846 above-- NO SUBSTITUTES
The lyre is NOT included in this
kit. You may pick one of the two lyres above.
1 set of part number SH998 pedals
1 Pair of SH770C Lyre Braces
1 Set of SH773 Pedal Rods
3 Pairs of Pedal Mounting Brackets
(to be mounted in the lower box)
Kit Part Number- SH849
your grand has only two pedals, use these lyres, but leave one pedal only as decoration.
PIANO LYRE BRACES AND PEDAL RODS
CAUTION: We have had so many rods returned that we are using a harsher policy
on returns. We now charge a 50% restocking fee on these rods. If the rods turn
to be too long, try to shorten them and make them fit. You must measure carefully before ordering.
Lyre Braces- Brass plated
steel- Grand- See nos 30558A and B in graphic above
You may have to reset the mounting points.
Perfect fit using old holes
If you must return
them, the 50% restocking fee applies.
21 inches long- Pair-
Braces- SOLID BRASS- Grand- See nos 30558A and B in graphic
You may have to reset
the mounting points.
fit using old holes is RARE
23 inches long- Pair-
21 inches long- Pair-
14 inches long- Pair-
SH770B $ 49.75
SH770A $ 33.25
Pedal rods- Grand-
Sold Brass with adjustable brass collar and set screw-
in graphic above-- Set of 3-
SH972 $ 96.25
diameter- Set of 3- Adjuster nut and tip
Adjustable from 20 5/8" to 21 3/8" PT81AB $85.00
$ 72.500 a pair
AND UPRIGHT DESKS AND LID PROPS
TO SEE THE RODS AND BRACES
TIME LEGS, LYRE, DESK, AND BENCH
is no way around it. These are well made products, but they are very expensive.
This is because there
are so few ordered due to the few number of old pianos
being restored. We are talking here about going
clear back to the Victorian
Era in style.
products below are unfinished.
products in this section are subject to a 30% restocking fee. Our supplier will
the product was defective before being shipped, and their verdict
is final. Anyone who damages the
product and tries to get a refund will NOT
receive ANY refund. Returns MUST be arranged by us, not
Prepayment is required.
No credit card purchases accepted on the Old Time products.
prices may not be final. We will check with our supplier to see if a price increase
has been added.
AND LYRE MATCHING
you have a square grand needing four legs and a lyre,
SEND MAIL for a quote on adding one leg to the set.
set of three legs and the lyre are made of poplar. Legs and lyre are routed to
receive your existing mounting hardware. If your piano does not use the round
cast iron mounting disks, we can supply them to be paid for separately.
very careful measurements of your piano and do the math with the following dimensions.
If, after you receive the products, something is wrong, the restocking fee WILL
Piano round mounting plates here
Height- 22-3/4 inches
Width- 5-1/2 inches
Length of top piece- 15-1/4 inches
Height- 20-1/2 inches
Base Depth- 5-1/2 inches
Base Length- 12 inches
Full set - $ 2950
Three legs - $ 2000
Lyre only - $1050
MATCHING THE LEGS ABOVE
unfinished solid birch is used. Music storage area is under hinged lid. Hardware
18-1/2 inches - Width- 15-1/2 inches - Length- 36 inches
ARTIST BENCH LEGS
MATCHING THE PIANO LEGS ABOVE
legs are ONLY made to fit on artists benches.
You will need to do any retrofitting
are very ornate, and much time goes into making them. Thus, the price is very
high. As far as we know, this is the only Square Grand desk anywhere.
The desks are made of
seven ply birch and faced on both sides with maple, mahogany, or rosewood.
Special sizes not possible.
You may need to relocate the hinge points to fit the desk if you wish to use one
All three styles same price
Maple-- $ 530
Mahogany-- $ 565
Rosewood-- $ 755
POLICY ON WOOD AND FURNITURE PARTS
you receive wood parts which must be stained and finished,
EXAMINE IT BEFORE
If there is any flaw which you cannot deal with, it must be returned.
If you alter the product, or if you stain it, we cannot return your payment.
Our supplier will not take back a product which has been altered of worked
Also, you must call us at (800) 338-8863
for instructions to return the product.
If you return it to us, we will deduct
your shipping costs to return it to our supplier.
must be returned to our supplier.
If you send it back without notifying
us and following instructions, you may not
receive a refund if our suppler
does not know you are our customer.
ORDER BY PHONE WITH CREDIT CARD
TOLL FREE: (800) 338-8863
If there is no answer, please leave
a message- we do answer our voicemail
Go to Mail Order Form for printing:
Online help available